1.In a conventional light channel, a high power light source has a small cooling surface, that is, there are a large number of radiators that cannot output heat quickly, so the light decays quickly. UV LED surface light source and UV LED spot light are the same cooling surface times, the thermal effect is very good. Life can last anywhere from 25,000 to 30,000 hours. Life is not affected by the number of times of opening and closing. The cable output is used. Compared with the traditional lamp mode to replace frequent lamps, high power consumption requires UV fiber output and LED UV cable output. You can reduce the cost of equipment and provide equipment utilization.

2.The peak of UV LED luminescence is 365nm, 360nm~370nm, no infrared emission. So the surface of the product is not heated to raise the temperature. The traditional lamp UV irradiation machine usually increases the surface of irradiated product by 60-90 degrees. So the positioning displacement of the product leads to bad products.

3.Many UV LED luminescence points are uniformly distributed, and several groups of professional lens groups are optimized for UV light design. The irradiation intensity of uniform lighting, edge and center is no more than 3%.

4.UV LED optical output stability is good, light intensity, high energy, good uniformity, instant light, 100% power UV output, strength up to 1200mW/cm2 (depends on wavelength), effective luminous efficiency 10 times higher than mercury mercury lamp, improve working efficiency.

5.Customize the shape and size of luminescent area according to user’s needs.

6.UV LED light source does not use lamp preheating, does not contain toxic mercury. Compared with traditional lamp tube, the power consumption is several hundred watts, even kilowatts, use preheat for about 10 minutes, the lamp also contains toxic mercury. However, LED UV surface light source is a safe choices more in line with the requirements of energy conservation and environmental protection.

7.The volume of UV LED controller is about the volume of traditional lamps and lanterns, and the volume of camera is 1/10, which makes the installation of the device easier and reduces the occupied area of the production site.